WREN Fat Bike Suspension Fork
The Inverted Design
The Inverted fork design simply works better. By inverting the fork so that the lighter stanchions are on the bottom, we reduce the mass of the moving part of the fork so that it will react quicker and easier to the trail. Inverting also anchors the stanchions into the stronger, larger upper tubes and crown making the overall chassis much stronger and stiffer. It also lowers the fulcrum point where the uppers join the stanchions compared to other fork designs decreasing the leverage factor. Inverting also positions the seals downward so that all kinds of bad stuff doesn’t sit on them and get pulled into your fork.
The Wren TwinAir System
The Wren TwinAir System is designed to fine tune the ride of the fork using only your air pump. No dis-assembly required. The TwinAir system is considered a single positive air chamber and is located at the bottom of the air side stanchion. We divide this chamber in half using a floating piston. There are individual air valves for the top and bottom chambers. By dividing the one large volume into two smaller volumes, the forces necessary to move the air are reduced allowing the fork to begin moving easier and faster. Because the piston floats, air pressure will equalize on either side of the piston as you add or release air, but the volumes of each chamber will change. More air in the top chamber will increase its volume relative to the bottom chamber and the fork will exhibit a more plush ride. If the bottom chamber volume is larger relative to the top, the fork will exhibit a stiffer, more progressive ride.
Keyed Stanchions keep Wren suspension forks running true and prevent the stanchions from turning. The 43mm beefy uppers are channeled to accept brass keys that fit to our oversize 36mm stanchions. The keys perfectly align the stanchions in the uppers and are designed to shear should you take a really big hit. This protects the channels and your fork from damage. The fork will still function and the keys are easily replaced.
Inverted Fat Bike Suspension Fork | Fat Bike Suspension | MTB mountain bicycle
Air Spring Side
Tire Size: Width – 135mm hub is 4.0″ and 150mm hub is 5.0″. Please refer to the tire size chart below.
Wheel Size*: 26″ to 29″. Please refer to the wheel size chart below.
Steerer: AL7050 Tapered – 1.125″ ~ 1.5″ / AL7050 Straight – 1.125″ (special order)
Crown: AL6066T6 3D forged
Stanchions: AL7050 hard anodized, 36mm
Uppers: AL7050 hard anodized, 43mm
Axle: QR15 or Bolt-on
Brake: Post mount
Right side – sealed oil cartridge, adjustable rebound and compression with true lockout.
Left side – TwinAir System, fully adjustable.
110mm Travel – 2221 g / 4.9 lb
150mmTravel – 2333 g / 5.1 lb
110mm Travel – 2151 g / 4.7 lb
150mm Travel – 2280 g / 5.0 lb
*Travel might be limited due to size of wheel/tire combination
|Fork Model||Travel Only||Travel/AC Together|